VERICUT is a true knowledge-based machining system: through the simulation process, it learns the exact depth, width, and angle of each cut. And it knows exactly how much material is removed by each cut segment. With that knowledge, OptiPath divides the motion into smaller segments. Where necessary, based on the amount of material removed in each segment, it assigns the best feed rate for each cutting condition encountered. It then outputs a new tool path, identical to the original but with improved feed rates. It does not alter the trajectory.
4½ hours of programmer time spent on optimisation saved us $75,000!
Aerospace Dynamics, International
Simple Setup and Use
A setup wizard prompts you for cutter settings as you machine the part. Essentially, you add intelligence to the cutter. All the settings for that cutter are stored in an optimisation library. You define the settings once. Every time you use that cutter the results can be instantly optimised!
OptiPath also features a “learn mode” for creating the optimisation library with no setup required. For each tool, OptiPath finds the maximum volume removal rate and chip thickness and uses them to determine the optimisation settings for the tool.
How it Works…
As the cutting tool encounters more material, feed rates decrease; as less material is removed, the feed rates speed up accordingly. Based on the amount of material removed by each cut segment, OptiPath automatically calculates and inserts improved feed rates where necessary. Without changing the trajectory, OptiPath writes the updated feed rates to a new NC program.
Could You Benefit from OptiPath?
Do any of the following sound familiar? If so, OptiPath can help!
- Removing a lot of material
- Long machining times
- Large NC programs
- Interrupted cuts (multiple entry/exit)
- Cutting at variable depths/widths
- High speed machining
- Thin wall machining
- Delicate tooling and materials
- Expensive tooling and materials
- Premature cutter wear/failure
- Optimising programs “by ear”
- Reworking programs for feeds/speeds… or no time to do so
- CAM system and/or programmers don’t have necessary knowledge
- “Resident expert” retiring/leaving
- Poor surface finish
- Excessive bench time
- Cutter deflection problems
- Chatter in corners
- Air cuts or light cuts at slow or programmed feed rates